Dismantling Instructions - Philips MCM720 Service Manual

DISMANTLING INSTRUCTIONS

Dismantling of the Cover Cassette and Universal Loader
1) Push 1 catch each on the left & right side then remove
the Cover Cassette in the direction as shown in Figure 1
and Figure 1A.
2) Loosen 8 screws to remove the Cover Top by sliding
it out towards the rear before lifting up.
- 6 screws on the rear
- 1 screw each on the left & right side
3) Loosen 2 screws each to remove the Panel Left and
Panel Right. The Panels are removed by sliding it
towards the rear and outwards.
- 1 screw on the rear
- 1 screw on the side
- see Service position A
6) Loosen 2 screws A (see Figure 2) to remove the Bracket
Module Mounting and CD Module.
- 1 screw each on the left & right side
Push catches on two sides
Figure 1A
Detaching the Front Panel assembly from the Bottom/Rear assembly
1) Remove 2 screws B (see Figure 3) from the bottom of the
Cabinet Front.
B
Figure 3
4-1
Lift up and out
Figure 1
A
Figure 2
2) Release the fixation of the Combi Board (pos1102-1003)
to Bracket Combi (pos 155) by releasing the 2 catches C1
(see Figure 7) and pulling the Combi Board outwards as
shown in Figure 7A.
3) Uncatch 2 catches C2 (see Figure 7) on the left & right
sides of the Cabinet Front (pos 101) and slides the Front
Panel assembly out towards the front.
- see Service position C
Detaching the Front Panel assembly from the Bottom/Rear assembly
Figure 4A
Dismantling of the Front Panel assembly
1) The Knob Volume can be remove by pulling it out
in the direction as shown in Figure 5.
2)
Loosen 3 screws C (see Figure 6) to remove the Bracket
Front Cabinet Display.
3) Loosen 3 screws D (see Figure 6) to remove Front
Display Board.
4)
Loosen 2 screws E (see Figure 6) to remove the
Headphone Board.
5)
Loosen 4 screws F (see Figure 7) to remove the Module
4
Tape Deck.
4-1
Figure 4
Figure 5