Table of Contents
Advertisement
This service manual does not describe SPECIFIC SERVICE INSTRUCTIONS.
3.1
Main body (Used figure are TH-D7E and TH-D7US)
3.1.1 Removing the METAL COVER (See Fig.1, 2)
(1) Remove the four screws A attaching the METAL COVER.
(See Fig.1)
(2) Remove the one screw B attaching the METAL COVER.
(See Fig.1)
When remove the screw B use a screwdriver shown as
follows.
TORX Driver: size T10
Parts number: DR-L70
(3) Remove the two screws C attaching the both side of
METAL COVER. (See Fig.2)
3.1.2 Removing the TUNER PACK (See Fig.3, 4)
(1) Disconnect the card wire from the MAIN BOARD assembly
connected to TUNER PACK. (See Fig.3)
(2) Remove the two screws D attaching the TUNER PACK.
(See Fig.4)
1-12 (No.MB638)
SECTION 2
SPECIFIC SERVICE INSTRUCTIONS
SECTION 3
DISASSEMBLY
A
B
Fig.1
Fig.2
Fig.3
Fig.4
A
C
Tunerpack
connector
D
Advertisement
Table of Contents
