Table of Contents
Advertisement
tion comes bound to the copter and the CGOET from the factory, and controls
both the copter and the CGOET Gimbal Camera.
NOTICE: After switching from single mode to team mode (Wizard and ST16) on
the ST16 , the Wizard must be bound to the copter and the ST16 Ground Station
must be bound to the camera.The Wizard controls the copter and the ST16
Ground Station controls the CGOET Gimbal Camera.
If you need to switch back to single mode, the operation steps are as follows:
Step 1) Tap the settings icon [
] on the ST16 and then switch from team
mode to single mode.
Step 2) When the Main LED Status Indicator starts to blink, the copter enters
binding mode.
Step 3) Wait for a few seconds, as the remote control will automatically bind to
the camera and copter. You will hear two beeps from the aircraft when the bind-
ing is successful.
TEAM MODE (Two ST16 Ground Station)
BINDING A NEW ST16 TO TYPHOON H
Step 1) Switch on the original and the new ST16 Ground Stations first, and then
power on Typhoon H. Do not touch it until the initialization completes. Wait a few
seconds for the camera to align and all system (RC and video link) connected.
Step 2) Tap the settings icon [
] in the lower right column of the original
ST16, and then switch from single mode to team mode (At this time, the copter
cannot be controlled by the original ST16 anymore, but the CGOET gimbal
camera can still be controlled by the original ST16) .
NOTICE: When the system is switched from single mode to team mode on the
original ST16, the Typhoon H Main Status Indicator will start to flash orange rap-
idly, which means the copter enters binding mode.
10
Advertisement
Table of Contents
