Parts Ordering; Parts Kits; Parts List - Emerson Fisher 1051 Instruction Manual

Instruction Manual
D101322X012
2. If you are going to leave the bolt threaded into the cover, lock it with the jam nut (key 128) so that it cannot be
screwed into the cover and interfere with normal actuator operation.
To Lock the Actuator
1. Make sure the actuator diaphragm rod is retracted fully (the locked position of the valve). For a push‐down‐to‐close
valve and actuator, the valve will be fully open when locked. For a push‐down‐to‐open valve and actuator, the valve
will be fully closed when locked.
2. Make sure the jam nut (key 128) is loose. Then, screw the threaded bolt into the cover until it contacts the actuator
lever.
3. Rotate the threaded bolt until one of the holes in the locking disc (which is welded to the bolt) is in line with the
hole in the mounting plate (key 123). Tighten the jam nut against the cover.
4. Lock the plate and disc together with a padlock (not furnished by Emerson Automation Solutions).

Parts Ordering

When corresponding with your
number found on the actuator nameplate.
WARNING
Use only genuine Fisher replacement parts. Components that are not supplied by Emerson Automation Solutions should
not, under any circumstances, be used in any Fisher valve, because they may void your warranty, might adversely affect the
performance of the valve, and could cause personal injury and property damage.

Parts Kits

Key Description
Retrofit Kits
Kit provides parts to add a top‐mounted handwheel.
Kit number 1 includes the handwheel assembly only.
Kit number 2 includes Kit number 1 and a new Upper
Case (key 1) required to mount the handwheel assembly.
Kit Number 1
Kit Number 2

Parts List

Note
Contact your Emerson sales office
Ordering information.
*Recommended spare parts
Emerson sales office
Part Number
28A1205X082
28A1205X092
or Local Business Partner for Part
or Local Business Partner about this equipment, refer to the serial
Basic Actuator With F and G
Mounting Adaptations (figures 9
and 10)
Key Description
1 Upper Diaphragm Case, zinc plated steel
3* Diaphragm
NBR (nitrile)
VMQ (silicone)
4 Diaphragm Plate, Cast Iron
5 Cap Screw, plated steel (12 req'd)
6 Hex Nut, plated steel (12 req'd)
8 Travel Stop, plated steel (2 req'd)
9 Hex Socket Cap Screw, steel
10 Diaphragm Rod/Bearing Assembly, steel/PTFE
11 Spring, painted steel
13 Spring Seat
18 Cap Screw, plated steel
20 Housing, cast iron
20A Housing Assembly
21 Cap Screw, plated steel (2 req'd)
22 Mounting Yoke, painted steel
(not included w/ H mounting adaptation)
23 Cap Screw, plated steel (4 req'd)
27 Lever, ductile iron
28 Hex Cap Screw, plated steel
1051 and 1052 Size 33 Actuators
June 2017
23