Pro 2 Installation Guide Common-Rail Pro 2 Common-Rail PEBAEN41CI12...
Page 3
Scope of delivery RaceChip Pro 2 Cable harness: fi t for Blind-Plug; if you want to put Installation Guide for for your Common-Rail your vehicle your vehicle back into its Common-Rail vehicles standard level (Picture can vary) (Picture can vary)
Page 4
Tuning on a safe and high quality level - technically as well as with the selection of electronic modules - has always The RaceChip team works with the utmost diligence to off er you a reliable device. We are proud that all modules of the been our benchmark.
Please take care not to install the RaceChip too close to heat The function of the blind-plug is to reset the car to its original sources. The cable of the RaceChip is to be led downwards.
Page 6
Remove motor cover and locate the Common-Rail-Sensor 1. Approach the car with appropriate 3. Please disconnect the 3-pin plug. tools. Please open the bonnet and Insert the plug of the cable harness remove the motor cover (if any). into the sensor. 2.
Page 7
5. The cable harness is now installed. 6. Assemble the cable harness with plug of your vehicle with the counter- Please connect the RaceChip Pro 2 the cable ties. An assembly to already part of supplied cable harness. with the cable harness. The plug will existing harnesses will be only fit one way.
Page 8
Factory setting of your RaceChip We deliver the RaceChip with a setting appropriate for your vehicle. This setting is the optimal adjustment of your vehicle software to the RaceChip software and perfectly combines the following points: longevity of your motor, reasonable - but not maximum - performance output as well as fuel saving.
Page 9
Fine-tuning of your RaceChip In case the factory setting on your invoice (see page 9) is B-1, F-E, D-F, C-E or E-0, we recommend the following adjustments for a performance increase. On the left side you can see an example of the adjustment of the two rotary control switches from B-1 to D-1.
Page 10
Fine-tuning of your RaceChip The RaceChip Pro 2 will be delivered with an adjustment appropriate for your vehicle. In rare cases, a too high or too low per- formance output due to manufacturer-determined serial tolerances might occur. This might likewise result in error messages on the vehicle‘s display.
Page 11
An error message appears on the display of the dashboard. With installation of a RaceChip, the safety programmes (emergency program) of your vehicle aren’t switched off - this is a great advantage for you. When the malfunction light of the motor shows up on your cockpit it normally means that the Race- Chip provides too much performance.
Page 12
RaceChip Chiptuning GmbH & Co. KG Your RaceChip retail specialist Phone +49 (0) 7023 - 77 999 - 0 Internet http://www.racechip.com Support http://support.racechip.de...
Need help?
Do you have a question about the Pro 2 and is the answer not in the manual?
Questions and answers