Advertisement
4
Remove only the yellow tape from each ink cartridge.
Caution:
Do not remove any other labels or seals, or ink will
leak. Do not touch the green chip on the cartridge.
5
Insert the cartridge in the holder for each color. Press each
cartridge down until it clicks. Make sure all cartridges are
pushed down into place.
6
Lower the scanner unit, then press
ink delivery system.
7
The printer starts charging the ink. Ink charging takes
approximately 4 minutes.
Caution:
Don't turn off the printer while it is charging or you'll
waste ink.
Note:
• The printer is designed for use with Epson
third-party cartridges or ink.
• The cartridges included with the printer are designed for
printer setup and not for resale. After some ink is used for
charging, the rest is available for printing.
4
Load paper
1
Make sure the product is done charging ink. Then fl ip the
feeder guard forward, raise the paper support and tilt it
backwards slightly, and slide out the output tray.
to start charging the
cartridges only, not
®
2
Load paper, glossy or printable side up and short edge
fi rst, against the right side of the rear paper feed slot.
3
Slide the edge guide against the paper, but not too tightly,
and fl ip the feeder guard back.
5
Install software
Note:
If your computer does not have a CD/DVD drive or you are
using a Mac, an Internet connection is required to obtain the product
software.
1
Make sure the product is NOT CONNECTED to your
computer.
Windows
:
If you see a Found New Hardware screen, click
®
Cancel and disconnect the USB cable.
2
Insert the product CD or go to your product's support page to
download and run your product's software package:
www.epson.com.jm/support/xp241
3
Follow the instructions on the screen to run the setup
program.
OS X:
Make sure you install Software Updater to receive
fi rmware and software updates for your product.
4
When you see the Select Your Connection screen, select
one of the following, then continue with the on-screen
instructions:
• Wireless connection
In most cases, the software installer automatically
attempts to set up your wireless connection. If setup
is unsuccessful, you may need to enter your network
name (SSID) and password.
• Direct USB connection
Make sure you have the USB cable.
Advertisement
