General Hazards; Unpacking And Installation - GE SimpliNano Original Instructions Manual

1.5. General Hazards

There a number of warning labels and symbols that may be present on your
instrument. These are there to inform you where a potential danger exists or
particular caution is required. Before commencing installation, please take time to
familiarise yourself with these symbols and their meaning. This instrument is subject
to the following hazards:
CAUTION
Some of the above instruments contain a UV source which generates a light beam that traverses the sample
chamber and is accessible in the lamp chamber. Under normal use the lamp beam is confined within the instrument.
The unit should not be operated with the sample chamber lid open or the lamp housing lid removed as prolonged
exposure to the beam may cause permanent eye damage.(Not applicable to Ultrospec 10, Novaspec III/Plus)
WARNING
High voltages exist inside the Ultrospec 2100/7000/8000/9000, GeneQuant 100/1300, SimpliNano and NanoVue Plus
instruments. Repair and maintenance should only be carried out by individuals trained specifically to work on these
instruments.
CAUTION
These instruments may be connected to a separate PC. To preserve the integrity of the measuring equipment it is
essential that the attached PC itself conforms to basic safety and EMC standards and is set up in accordance with
the manufacturers' instructions. If in doubt consult the information that came with your PC. In common with all
computer operation the following safety precautions are advised.
• To reduce the chance of eye strain, set up the PC display with the correct viewing position, free from glare and with
appropriate brightness and contrast settings.
• To reduce the chance of cross contamination from biological samples, use appropriate personnel protection
measures and disinfectant wipes on keyboard and mouse
CAUTION, HOT SURFACE
• These instruments may be fitted with heated cell holder accessories that depending on operation may become hot
to touch. Care should be taken to avoid touching the heated accessory when running at elevated temperatures

1.6. Unpacking and installation

NanoVue Plus instrument
• Inspect the instrument for any signs of damage caused during transit. If any
damage is discovered, do not use the instrument and report the problem to your
supplier.
• Ensure your proposed installation site conforms to the environment conditions for
safe operation
• Indoor use
• 5 to 40°C
29-0047-78 AC 04-2014
External power supply
5