Haier HYC-68 Operation Manual page 7

FAQ
Do you have questions during using? Do you doubt that the refrigerator breaks
down? Please read description here. This chapter is to give answers in respect
of potential fault phenomenon as well as respective solutions.If your question is
still unresolved after operation, please contact Haier after-sales service.Do not
maintain and dismantle the refrigerator by yourself!
Fault
The refrigerator does not work
Whether there is certain clearance among stored articles
Refrigeration effects are not
Whether the refrigerator is exposed to direct sunlight or radiation of other heat sources
apparent, temperature
exceeds the standard
Whether part of the refrigerator contact external objects or wall
Noise is too significant The noise noted in technical data is average data measured in standard laboratory
without noise when the refrigerator with no stored articles is put on a rubber blanket
and operates steadily after the door is closed, and data measured during startup &
shutdown and at 1 m above the surface is not included. It is normal that actual noise
differs from stated value because of loaded articles, environmental noise, no door
closing, startup & shutdown of the compressor during using.
Whether the articles are newly put in the refrigerator and the temperature is not
stabilized at 3~7℃. The fault will be eliminated automatically after refrigeration for a
Alarm light flashes,
Whether the door is not closed completely, which triggers alarm of door opening
the buzzer alarms
Whether the power fails, the refrigerator returns to normal condition after starting up
16
Troubleshooting
Whether the input power meets the requirements
Whether the plug and socket are in loose contact
Whether the input line and control line break down
Whether the voltage is too low
Whether too much or too hot articles are stored
Whether the door is opened too often
Whether the ambient temperature is too high
Whether the air duct is blocked
Whether the refrigerator is placed steadily
while.
for a while
Whether the temperature exceeds the standard
Check refrigerator settings when restarting the refrigerator after power failure or the
power is shut off. Changes of settings may damage the articles stored.
The refrigerator shall be reconnected after more than 5 minutes once it is shut off, to
prevent damage to compressor or system.
Wear gloves when performing maintenance to prevent personal injuries due to sharp
edges or corners.
Hold the knob when closing the door to prevent finger pinching.
The angle of inclination shall not be greater than 45°when handling the refrigerator.
Be careful not to be tripped up by the refrigerator during handling, to prevent
refrigerator damage or personal injuries.
Do not lift or handle equipment with door knob to prevent refrigerator damage or
personal injuries.
Do not damage refrigerating circuit.
Do not use any electrical appliances inside the appliance, unless it is approved by the
manufacturer.
The appliance must be positioned so that the plug is accessible.
The appliance must be placed on a solid and flat surface, or excessive vibration and
noise may be produced when the appliance in operation.
The appliance can be used by children aged from 8 years and above and persons with
reduced physical, sensory or mental capacibilities or lack of experience and knowledge
if they have been given supervision or instruction concerning use of the appliance in a
safe way and understand the hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children without supervision.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a hazard.
Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of
obstruction.
If your cabinet is to be discard, you must remove the door and leave the shelves in
place. This will reduce the posibility of danger to children. And the flammable foaming
needs to be disposed by professional persons.
CP/IP foaming materials are flammable, need professional processing.
5