Replacing X-Sensor - Janome MC9900 Additional Service Manual

Embroidery unit
Hide thumbs Also See for MC9900:
Table of Contents

Advertisement

MC 9900
w
q
e
e
w
q
r
t
y
Precision screwdriver

Replacing X-sensor

Removing X-sensor
z Disconnect the connector from printed circuit board
S1.
Pry up the lock tab of the connector with a precision
driver and pull out the brown e, orange q and red
w cords.
w
q
e
x Remove the setscrew r and t to remove the cord
guide plates.
Remove the tube from the cord guide plate.
c Remove the setscrew y.
Remove the X-sensor.
Attaching X-sensor
v Insert the brown e, orange q and red w cords
to the connector. Be sure that the cords are firmly
locked to the connector.
b Attach the connector to the printed circuit board S1.
Place the tube in the cord guide plates.
14
Precision screwdriver

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mc12000

Table of Contents