Mr. Coffee ECMP50 Instruction Manual With Recipes page 24

2. Make sure all controls are in the off position and the power cord is disconnected from
the electrical outlet. (See Section "CAUTION" on Page 4). Fill the reservoir with white
vinegar above the minimum level into reservoir.
3. Insert the brew basket (with filter) and place jar/carafe or regular cup on top of the drip
tray and under the brew basket.
4. Plug the power cord into the electrical outlet.
5. Press the red button to switch the unit on "I". Once the ready light " " becomes solid
green, press the brew button "
the brew position "
has been drained from the reservoir turn the side knob clockwise to the off position " ".
6. To remove any remaning traces of vinegar from the internal parts, repeat steps 2-5 above,
replacing the vinegar with water, as often necessary.
7. To clean the frothing tube internally, place a cup with cold water under the tip of the
frothing tube. Wait until the ready light "
tube into the water, press the steam button "
and once it becomes solid green again turn the side knob clockwise to the steam
position " ". Let the steam come out for about 10 seconds. This will clean any
residue left in the frothing tube from frothing milk.
8. Turn the side knob counter-clockwise to the off position " " and press the red switch to
the off position "O".
9. Repeat Steps 1 – 7 as necessary using only tap water to rinse any remaining traces of
vinegar out of the machine.
BVMC-ECMP50_15ESM1.indd 23
" and then turn the side control knob counter-clockwise to
". The vinegar will start flowing through the unit. Once all the vinegar
" becomes solid green. Insert the frothing
23
". The ready light " " will start blinking
10/12/14 9:56 AM