Table of Contents
Advertisement
Procedure in the event of a malfunction
The hob does not work
E is flashing in all the
hotplate displays and a
signal is sounding
The hob has switched itself
off
The circuit breaker in your
household electrical circuit
trips when you switch on
the hob
Repairs
E Ö display and numbers
Malfunctions often have simple explanations and may
be easily rectified. Please read the following
instructions before calling the after sales service.
Check whether there is a power supply to the
appliance. Check whether the circuit breaker or fuse
on your electric appliance has tripped.
The control panel is very dirty, food has been spilt or
an object has been placed on the work surface. Clean
the control panel thoroughly or remove the object
from the work surface. Press the control panel
concerned. The flashing stops.
The main switch was touched inadvertently. Switch
the hob back on. Adjust the settings again.
Make sure that the power draw of all the appliances
switched on does not exceed your maximum
household electricity supply. Check whether the
circuit breaker triggers when you switch on another
hotplate.
Repairs may only be carried out by trained
customer service personnel.
d
Incorrect repairs to the appliance may expose the
user to increased risks.
If E Ö and numbers appear in the display panels, there
is a fault in the electronics. Disconnect the appliance
from the mains and reconnect it. Consult the
after sales service if the display appears again.
17
Advertisement
Table of Contents
