Troubleshooting - Electrolux WASL6E202 User Manual

26 www.electrolux.com
compartment of the detergent
dispenser.
2. Start the programme to drain the
water
12.10 Frost precautions
If the appliance is installed in an area
where the temperature can be less than
0° C, remove the remaining water from the
inlet hose and the drain pump.
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. Put the two ends of the inlet hose in a
container and let the water flow out of
the hose.

13. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
13.1 Introduction
The start of the appliance does not occur or it stops during operation.
First try to find a solution to the problem (refer to the table). If not, contact the Authorised
Service Centre.
With some problems, the acoustic signals operate and the display shows an alarm
message:
CAUTION!
Deactivate the appliance before you do the checks.
13.2 Possible failures
Problems with alarm messages
Message
The display tells to check
the tap: the appliance
does not fill with water.
4. Empty the drain pump. Refer to the
emergency drain procedure.
5. When the drain pump is empty, install
the inlet hose again.
Possible solution
Make sure that the water tap is open.
Make sure that the pressure of the water supply is not
too low. For this information, contact your local water
authority.
Make sure that the water tap is not clogged or is furred
with lime-scale.
Make sure that the filter of the inlet hose and the filter of
the valve are not clogged. Refer to "Care and cleaning".
Make sure that the inlet hose is not damaged.
WARNING!
Make sure that the
temperature is more than 0
°C before you use the
appliance again.
The manufacturer is not
responsible for damages
caused by low temperatures.