Profoon PDX-2708 User Manual page 37

[ FLASH ]
Here you can set the interruption duration of the flash pulse (see also
paragraph 3.8):
- short setting: 100mS
- average setting: 300mS
- long setting: 600mS
Ask your telephone service provider or the supplier of your home or office
switchboard for the most suitable interruption time. The default flash time
of 100 mS is used in the Benelux, which is already set upon leaving the
factory.
[ PIN WIJZ ]
A PIN code is required for various settings and for registering and deregis-
tering handsets. The stand factory PIN code is 0000, but you can use this
menu to change this PIN code into your personal 4-digit PIN code.
1. make sure the display shows [ PIN WIJZ ]
2. press 2x the OK button
3. now first enter the old PIN code
4. press 2x the OK button
5. enter the new PIN code
6. press 2x the OK button
7. enter the new PIN code again
8. you'll hear a confirmation tone; the new PIN code is now stored
Instructions to restore the default factory PIN code 0000 in case you've
forgotten or lost your personal PIN code:
1. remove the power adaptor of the base from the wall socket
2. on the base, press the button AND KEEP THIS BUTTON DEPRESSED
3. now insert the adaptor back into the wall socket (keep the button
depressed)
4. after 5 seconds, release the button
5. the PIN-code is now changed back into 0000
37