Disassembly - Sanyo VHR-VX400 Service Manual

1. DISASSEMBLY
1-1.
REMOVAL OF CABINET, MECHANISM UNIT, AND MAIN BOARD
REMOVING THE CABINET PARTS (Fig. l-l-l)
REMOVING THE MECHANISM MAIN UNIT AND THE
1. Remove the cabinet by removing the four screws(1).
CP-1 PWB ASSEMBLY (Fig. 1-1-2
and l-l-3)
2. Remove the front panel by removing the locks of the clamps
After removing the cabinet parts, remove the mechanism unit
(A) using a screwdriver, etc. and slightly rotating the bottom
and the CP-I PWB assembly connected as follows.
part in the direction of the arrow.
1.
Notes: Electrical adjustments for the this model can be 2.
performed with only the cabinet removed.
3.
4.
Remove the three screws (2) as shown in Fig. 1-1-2.
Remove the two screws (3) at the CP-1 board, and then
disconnect the bottom cover.
Remove the two screws (4) and two screws (5) of the
mechanism unit. The two screws (5) of the cassette tray
can be removed easily by pushing the lid opener lever in the
arrow direction to remove the lock as shown in the enlarge
view.
Lift up the whole mechanism unit and main board (CP-1
PWB" assembly), and as shown in Fig. 1-1-3. so that they
can be removed from the chassis.
M-SE2LN/A-l
,6$'(')
Front P
(1)
Fig. 1-1-1
'-"
–6–