Installation; Appliance Usage Range; Climate Class; Starting - LG GBB59PZFZB Owner's Manual

INSTALLATION

INTRODUCTION
Installation

Appliance Usage Range

This appliance is intended to be used in household
and similar applications such as:
• staff kitchen areas in shops, offices and other
working environments;
• farm houses and by clients in hotels, motels
and other residential type environments;
• bed and breakfast type environments;
• catering and similar non-retail applications

Climate Class

The appliance is designed to operate at the limited
range of ambient temperature, depending on
climate zones. Do not use the appliance at the
temperature out of the limit. Climate class of your
appliance is indicated on the label with technical
description inside the fridge compartment.
Class Symbol
Extended
SN
Temperate
Temperate N
Subtropical ST
Tropical T
Installation
1. Select a good location. Place your fridge-freez-
er where it is easy to use.
2. Avoid placing the unit near heat sources, direct
sunlight or moisture.
3. To ensure proper air circulation around the
fridge-freezer, please maintain sufficient space
on both the sides as well as top and maintain
at least 2 inches (5cm) from the rear wall.
4. To avoid vibration, the unit must be leveled. If
required, adjust the leveling screws to compen-
sate for the uneven floor.
The front should be slightly higher than the
rear to aid in door closing. Leveling screws can
be turned easily by tipping the cabinet slightly.
Turn the leveling screws counterclockwise (
to raise the unit, clockwise (
5.
6.
7.
8.
Ambient temperature
range °C
+10 ~ +32
+16 ~ +32
+16 ~ +38
+16 ~ +43

Starting

When your fridge-freezer is installed, allow it 2-3
hours to stabilize at normal operating temperature
prior to filling it with fresh or frozen foods. If power
plug is disconnected, allow 5 minutes delay before
restarting. Your fridge-freezer is now ready for use.

Operation

Identification of Parts

Refer to Refrigerator drawings at the end of the
manual:
If you fi nd some parts missing from your unit, they may
be parts only used in other models.
8
)
9
) to lower it.
10
8 8
Clean your fridge-freezer thoroughly and wipe
off all dust accumulated during shipping.
Install accessories such as ice cube box, etc., in
their proper places. They are packed together
to prevent possible damage during shipment.
Connect the power supply cord (or plug) to the
outlet. Don't double up with other appliances
on the same outlet.
To provide necessary air circulation, you should
leave enough space on each side, top and
behind the refrigerator-freezer.
Set the limit stops in the upper corners of the
back plate of the device as shown in Fig. 1.
Stops (2) can be found in the drawer inside
refrigerator compartment.
1
2
Fig. 1. Push Stopper (2) onto part (1) until the
end
Fig. 2. Push the refrigerator to the wall.
Bottle Rack (Optional)
Removable Glass Shelf (1 to 4)
Folding Glass Shelf (Optional)