Remote Switch Connection - Kohler 4CKM Operation And Installation Manual

WARNING
Hazardous voltage.
Backfeed to utility system can cause severe
injury, death, or property damage.
Do not connect to any building electrical system
without connecting through an approved device
and after building main switch is open.
Hazardous "backfeed" voltage can cause severe
injury or death. The generator must not be used to
" backfeed" by connecting it to building/campground
circuits. Install a transfer switch in standby power
installations to prevent connection of standby and other
sources of power. Electrical backfeed into a utility
electrical system can cause serious injury or death to
utility personnel working on transmission lines.
TP-5393 9/93

Remote Switch Connection

Kohler offers a remote switch panel for mounting on the
dashboard or elsewhere in the vehicle. It measures 2 in.
x 4 in. (51 mm x 103 mm) and requires a cutout of 1 3/4
in. x 3 1/4 in. (44 mm x 83 mm). The panel includes
start-stop switch, generator ON light, and a digital
hourmeter. Kohler also offers wiring harnesses of
different lengths with keyed plugs or pigtails for quick
connection between the controller on the set
(Figure 6-27) and the remote-switch panel in the
vehicle. Part numbers of these are listed in the chart on
the following page. The wiring diagram shown in
Figure 6-28 may be useful if the installer elects to use
just a start-stop switch or separate lights and hourmeter.
1. Remote Connection
Figure 6-27. Controller— Remote Connection
1
1-905
Installation 6-25