Cardio Zone Fast Track Owner's Manual page 13

Table of Contents

Advertisement

MODE
B. Function of
1. In Ready Mode, press
" to select the desired programs P1 – P6.
2. MANUAL function :
2.1
When MANUAL LED is flash you can press
flash and light. When TIME LED is flash you can adjust time.
2.2
After press
" to control the angle of treadmill and accelerate or decelerate.
3. P1~P6 program setup mode (There are 12 sections in every PROGRAM)
( 1 ) When MANUAL LED is flash press "
choice in P1~P6 is flash then press
light.
( 2 ) After entering the program you choose, the CALORIES window will display L1-L3
level for selection. You can press "
prefer then press
( 3 ) After selecting the level (L1-L3,) TIME indication will flash and press
"
or
stop flashing after confirmation.
** Time pre-set values is : 25(min) ; Time range : 5~99(min)
( 4 ) Press
of speed and angle. The change will follow by setup number. The setup of first time is 2
minutes and after is one minute for every time. When time is ready the speed and angle will
change directly. (Press "
( 5 ) If
is pressed in Program Setup Mode (P1-P6), the treadmill will set to defaults,
and begin the program immediately. All the defaults will adopt the preset parameters
automatically. Press "
restore the setup of PROGRAM in next session.
( 6 ) In this treadmill, P1 has its setup program and the means is :
P1 9 HOLE: This program simulates the motion of golfers walking in a golf course and
( 7 ) In every PROGRAM of L1~L3 there is one minute to warm up and at the same time it is
also the beginning of speed in every LEVEL.
( 8 ) The treadmill installed PROGRAM values are as the following:
key
, the MANUAL LED will flash and you can press
the motor will start at 0.5MPH and you can press "
to confirm.
" to set up the time, and press
the treadmill will work by number of setup. There are 12 kinds of changes
or
or
the resistance level is based on uphill and downhill movement. The entire
program is approximately 3828 yards or 3500 meters and will stop
automatically once the distance is reached.
and the MANUAL will stop to
" until the LED light of your
or
to confirm. After into program setup the LED will
" to choose which level (L1-L3) you
or
to confirm. TIME indication will
" to control speed.)
" to change setup in PROGRAM. But it will
12
or
or

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Fast Track and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents