Section 8-Anti-Tipper; Anti-Tipper Adjustment/Replacement; Anti-Tipper Adjustment - Invacare A4 Owner's Manual

Hide thumbs Also See for A4:

Table of Contents

SECTION 8—ANTI-TIPPER

After any adjustments, repair or service and before use, make sure all attaching hardware is

tightened securely - otherwise injury or damage may occur.

Anti-tippers MUST be attached at all times. Inasmuch as the anti-tippers are an option on this

wheelchair (You may order it with or without the anti-tippers), Invacare strongly recommends

ordering the anti-tippers as an additional safeguard for the wheelchair user.

Anti-tippers MUST be fully engaged. Ensure the release button of the anti-tipper fully protrudes

out of the hole in the anti-tipper socket.

Ensure both anti-tippers are adjusted to the same height.

NOTE: To ensure the correct model anti‐tipper is used refer to FIGURE 1. Measurements for anti‐tippers are approximate and are taken

using the TOP adjustment hole on the anti‐tipper (DETAIL ʺAʺ).

When anti-tippers are used, anti-tippers MUST be adjusted to maintain a 1-

clearance between the bottom of the anti-tipper wheels and the ground/floor. This spacing

should always be checked whenever adjustments/changes are made to the wheelchair. Failure to

maintain proper spacing may result in the chair tipping over backward causing serious injury or

property damage.

Press in the release button that secures the anti‐tipper wheels to the anti‐tipper bar.

Adjust the height of the anti‐tipper wheels to between 1

Repeat STEPS 1‐2 for the opposite anti‐tipper.

A4 Owner's Manual

WARNING

and 2 inches of the ground/floor.

to 2 inch

Part No 1110545

Table of Contents