Problem
Water drips from
the soleplate after
the iron has cooled
down or has been
stored (GC3116/
GC3114/GC3113/
GC3111/GC3109/
GC3106).
The iron does not
produce a steam
boost.
Possible cause
You have put the iron in
horizontal position while
there was still water in the
water tank.
You used the steam boost
function too often within a
short period.
The iron is not hot enough.
Solution
Always set the steam control to position 0 and
empty the water tank after use. Store the iron
on its heel.
Continue ironing in horizontal position and wait
a while before you use the steam boost function
again.
Set an ironing temperature at which the steam
boost function can be used (temperature
settings 2 to MAX). Put the iron on its heel
and wait until the temperature light goes out
before you use the steam boost function.
EnGlish
11