Service Menu - Bosch CRC200 Installation Instructions For Contractors

16 | Service menu

8 Service menu
▶ If the standard display is active, press and hold the menu
button for about three seconds until the service menu
appears in the main menu.
▶ Press the dial to open the already highlighted service
menu .
Main Menu
Service
System Data
HC assignment
Auto-Config.
Pump conn.
Heat. System
Control type
Ext.RoomSens.
DHW
LLH Sensor
Recirculation
Solar module
WWSD
Min.outs.temp
Damping
Building Type
Reset All
Heating circ.
Design Temp.
Base line
Base point
Max. Suppl.T.
Fig. 12 Overview of the service menu
1) Available only on the user interface for heating zone 1.
2) Available if supported by heat source.
6 720 821 651 (2017/05)
PID charact.
Opt. pump run
Room influence
Contin. heat
Frost protect
1)
Frost thresh.
DHW Priority
Function Test
Activation
2)
System pump
1)
HC Pump
1)
Info
Outdoor Temp.
1)
Appl. oper.
Appl.set sply
Appl.act.sply
Appl.max.sply
LLH Temp.
HC Operation
HC set.sply
HC act. sply.
Set Room Temp
▶ Turn the dial to select a menu item or change the value of a
setting.
▶ Press the dial to open the selected menu item, activate the
input field for a setting or confirm a setting.
Room Temp.
DHW Operation
Set DHW Temp
DHW Temp.
Maintenance
Maint.message
Maint. date
Reset Maint.
Current Fault
Fault History
Clear Fault
System info
Install.date
Control unit
Control SW
SW controller
HC Module SW
6 720 821 651-18.2O
CRC200
1)
1)
1)