Advertisement
© Panduit Corp. 2015
TROUBLESHOOTING
SYMPTOM
Tool will not operate. No air pressure at tool.
Tool will not cut off
A. Air pressure too low.
cable tie.
B. Tool has reached end of stroke.
C. Tool cutter blade is broken or dull.
Gripper will not return
Material wedged in nose area.
to forward position.
Cable tie is slipping in
Gripper is worn or damaged.
gripper.
Cable tie is too loose
A. Tool tension setting is too low.
on bundle.
B. Operator holding tool at angle to
C. Tool is held away from bundle by
D. Tool is pulled on as tie is being
Cable tie is too tight
Tool tension setting is too high.
on bundle.
Cable ties will not stay
Wire bundle exceeds maximum diame-
on bundle.
ter for specific tie being applied.
Air leaks from tool.
A. Loose or bad fittings.
B. Worn or bad hoses.
C. Worn or bad air cylinder assembly.
NOTE: In the interest of higher quality and value, Panduit products are continually being improved and updated.
Consequently, pictures may vary from the enclosed product.
E-mail:
techsupport@panduit.com
EU Website:
www.panduit.com/emea
EU Email:
emeatoolservicecenter
@panduit.com
OPERATION INSTRUCTIONS
POSSIBLE CAUSE
bundle.
previously
installed
cable
harness support, or other object on
bundle.
tensioned.
Verify that air supply is "on", and that connections are good
to be sure that tool is receiving air.
A. Check air supply regulator for proper adjustment.
Increase air pressure if necessary.
B. Release trigger and squeeze again.
C. Replace blade using KPPTEHB Blade Replacement Kit.
Contact Panduit.
Depress trigger and maintain in a depressed position while
removing materials from nose area.
Replace gripper using KPPTEHG Gripper Replacement
Kit. Contact Panduit.
A. Check selector knob for proper setting for specific cable
tie being applied (See Tension Adjustment).
B. Hold tool perpendicular to bundle in both directions.
C. Do not install cable ties too close to other cable ties,
tie,
harness supports or other objects on bundle.
D. Allow tool to seek its own position as the tie is being
tensioned.
Check selector knob for proper setting for specific cable tie
being applied (See Tension Adjustment).
Operator should dress the wires to result in a more compact
bundle.
Contact Panduit.
Panduit Electrical Headquarters (USA)
www.panduit.com
Page: 4 of 4
CORRECTIVE ACTION
Technical Support:
16530 W. 163rd Street
Lockport, IL 60441 U.S.A.
1-800-777-3300
Panduit EMEA Service Center (EUR)
EMEA Tool Service Center
Bedrijvenpark Twente 360
7602 KL Almelo
tel + 31 546 580 451
PPTEH
Advertisement
