Denon DN-508A User Manual page 5

Setup
Items not listed under
1. Use the included Euroblock connectors to connect the inputs on the rear panel to your
audio sources.
• Each zone input has a ground (G), cold/negative (–), and hot/positive (+) connector.
2. Use the included Euroblock connectors to connect the outputs on the rear panel to your
loudspeakers.
• Each zone output has a connector for common (COM), 4Ω, 70V, and 100V.
3. Use the included power cable to connect the power inlet to a power outlet.
4. Power on all of your audio sources (Blu-ray
etc.).
5. Press the power switch to power on DN-508A.
6. Adjust the level knobs for each zone input as necessary.
Example:
Amplifier
Microphones
Zone 1
Introduction Box Contents
To Zone Speakers
Blu-ray Player
Zone 2 Zone 3
are sold separately.
®
players, stereos, microphones, amplifiers,
SOURCE SELECT
ZONE 2 ZONE 2 ZONE 3 ZONE 3 INFO OPTION
ON/OFF SOURCE ON/OFF SOURCE STATUS DIMMER 1 CBL/SAT 2 Blu-ray
ENTER VIDEO L - AUDIO - R
PHONES BACK SETUP
AUX 1
HDMI 7 5V/1A
AUX 1
Receiver
Zone 4 Zone 5
MASTER VOLUME
QUICK SELECT
3 GAME 4 NETWORK
SETUP MIC
IN-Command
S E R I E S
AVR-X4000
INTEGRATED NETWORK AV RECEIVER
Power
Zone 6
5