Alesis ELEVATE 3 MKII User Manual page 5

Features
Rear Panel
1. Rear Port: The rear port enhances the
bass generated
increasing the low frequencies. Make
sure these ports are not obstructed
since this will adversely affect bass
response.
2. RCA Inputs: Use the included audio
cable or other RCA cables (sold
separately) to connect external sound
sources to these inputs.
3. Stereo/Sub Out: This is a full range
audio output which can be connected
to a mixer, powered speakers, or an
external recording device.
4. Bass Boost: This 2-position switch
allows you to boost the speakers' bass
frequencies.
5. Output to Left Speaker: This is the
audio connection to the left speaker.
Use the included 1/8" interconnection
cable to connect the right speaker to
the left speaker.
6. Power Connector: Plug the included
AC adapter here.
Front Panel
1. Tweeter: This
frequencies.
2. Woofer: This
frequencies.
3. Headphones: Connect your 1/8" (3.5
mm) headphones to this output to
hear the
headphones.
headphones are connected to Elevate
3, you will not be able to hear sound
out of your
headphones are disconnected.
4. Vol/Power: This knob is used to turn
the speakers on and adjust their
volume. To turn on, simply turn up the
knob. You will feel a click when the
speakers turn on. A LED on the left
side of the speaker will illuminate. To
turn off, simply turn the volume all the
way down; the LED will turn off to let
you know that the speakers are off.
by the woofer,
outputs the
outputs the
mix through
Note that while
speakers until
2
3
5
high
1
low
your
2
the
1
4
6
3
1
5
1
2
4
5