dji Goggles User Manual page 10

DJI Goggles User Manual
Multiuser Mode
Multiuser Mode is suitable for dual (or more) aircraft operator control. In this mode, the Goggles
operators with a slave remote controller can view the environment in real-time FPV for more intuitive
control. Please note that only the Goggles will display live view and that the primary Goggles only
support head tracking.
Remote
Controller
(primary slave)
No live view,
only support
settings.
If the remote controller and Goggles are operated by one person but for two users, a
spotter who is able to instruct and give warning is required for safe flying.
Only the primary remote controller can switch flight modes.
Secondary Goggles do not support head tracking.
If two operators control the aircraft simultaneously, the commands from the primary slave
remote controller takes priority of aircraft movements (control sticks and gimbal dial). The
secondary slave remote controller only works if the primary slave remote controller is not
being operated for more than two seconds, whereas the primary slave remote controller
can always override it to regain control. The two remote controllers follow the same priority
for other commands.
Linking Method
1. Put on the Primary Goggles and power on.
2. Use the touch panel to enter "Tools > Settings > Linking Settings".
3. Select "Advanced Linking > Connect two sets of Goggles > Primary/Remote Controller" and
confirm. The linking status indicator will go solid red to wait for linking.
4. Press the Link button on the Mavic Pro. Once linked, the linking status indicator will turn solid green.
5. Select whether to connect with the remote controller in the Goggles. Next, power on the primary
slave remote controller and connect it with a mobile device, if required.
6. Launch the DJI GO 4 app and enter the camera view. Press
Linking > Primary Remote Controller". They will link after a few seconds.
7. Repeat the above steps for the secondary pair of Goggles and the slave remote controller.
Please note that you must select "Advanced Linking > Connect two sets of Goggles >
Secondary/Remote Controller" in the Goggles, and then select "Remote Controller Linking >
Secondary Remote Controller" on the mobile device.
10
©
2017 DJI All Rights Reserved.
Goggles (primary)
√ Live View
√ Head Tracking
√ Intelligent Flight
Mode
Goggles (secondary)
√ Live View
√ Intelligent Flight Mode
×
Head Tracking
Remote Controller
(secondary slave)
+2 s
Can't switch flight
modes.
No live view, only
support settings.
, then select "Remote Controller