Advertisement
Copy from USB device data to NVRAM: Just the reverse operation done by copy to USB call.
Previously copied nvram files ("nvblock_ ... .bin") are copied into TV. If there is no flash file or some of
them are available on USB, the available ones are copied. If no USB is connected, nothing happens.
The files could be in a folder in the USB or it could be just in the root.
TV will autamtically reset after the files are copied from USB to TV. It is required because of existing
power-off requirement.
•
Note : For Clone function USB stick (Copy to USB – Copy from USB) must be formatted to
FAT32. If USB is not formatted to FAT32 the other TVs will not accept cloned data and
performance issues will result
USB Option
If this option is set as "ON", TV will go on normal operation.
If it is set as "5V", TV can not use USB and MediaBrowser but USB port will have a voltage of 5 Volts
and any device plugged can be charged. HOTEL MODE should be enabled for "5V" feature.
It is set as "OFF", then USB ports will be disabled and power will be cut on USB ports. To be able to
use this feature,
-
"USBPowerOff" option has to be set as enabled from profile (hwprofile >
USBPorts/USBPowerOff).
OR
-
HOTEL MODE should be enabled.
Fixed Pic. Mode
If OFF is selected TV will go on normal operation. If It is ON Main menu/Picture quick menu/mode and
quick menu/picture zoom will be inaccessible.
Digital Tuner
If ON is selected TV will go on normal operation. If It is OFF TV will display "no signal" message
when tuned to digital channels existing in active channel list, and digital channels will not be detected
in auto or manual searches.
Multiple RC Support
If OFF is selected TV will go on normal operation. If It is ON RCU type (system code) that is chosen in
"RCU program menu" will be used. "RCU program menu" can be opened by RETURN-1-2-3-4
shortcut. The multiple RC support works on RC5 type of remote controllers. To active this feature, the
hotel mode should be active and from the hotel mode configuration menu, Multiple RC support should
be set as ON. A stand by cycle is necessary after programming the RCU, in order for this feature to
work correctly.
RC key
1
System Code
1
Hide quick links:
Advertisement
