Installing The Co Cylinder - SodaStream Source Quick Start Manual

INSTALLING THE CO CYLINDER

2
1. Place the SOURCE™Drinks Maker on a flat sturdy surface in an upright position.
Remove the back cover by putting your index finger into the hole, grasping the back
cover and pulling it away from the body of the Drinks Maker. Set the back cover
aside.
2. Remove seal and cap from the SodaStream CO cylinder. Tip the Drinks Maker
forward and insert the cylinder through the hole in the base and upward towards and
into the carbonating head.
3. Access the cylinder by inserting your fingers through the open back, turn the cylinder
to the right while applying gentle pressure until it is firmly held in place. Hand-
tighten only; DO NOT use tools.
4. Place the Drinks Maker back into the upright position. Reinstall the back cover by
tilting the cover towards you, fitting the slot at the bottom of the back cover onto the
upright tab at the rear of the base of the Drinks Maker and pushing the cover into
place onto the back of the Drinks Maker. Now you are ready to create the bubbles.
2