Advertisement
WARNING
Electrical
Shock Hazard
Do not plug into the electrical sup-
ply until the assembly
is complete.
Failure to do so could result in elec-
trical shock or injury°
Before assembling
vacuum, check the
PACKING LIST on the cover of the separate
Repair Parts List, Use this list to verify that
you have received all the components
of
your new Kenmore vacuum_
Remove the tape located below the dust
cover/filter cover on the motor case.
Tape
Attach
stretch hose
end to nozzle
as shown_
HANDLE ASSEMBLY
Remove the screw located just below the
top edge of the back of the vacuum°
Position the handle as shown in the illustra-
tion below_
Slide the handle into the opening at the top
of the vacuum°
Insert the screw so it passes through the
handle into the vacuum,
Begin to tighten the screw with your fingers.
It may be necessary
to adjust the handle
slightly.
Advertisement
