Replacing Armrest Arm Pad; Section 4-Seat/Back - Invacare Action3 Junior Service Manual

SECTION 3—ARMRESTS

Replacing Armrest Arm pad

NOTE: For this procedure, refer to FIGURE 3.3.
1. Remove the mounting screws that secure the arm pad to the armrest assembly.
2. Replace arm pad and securely tighten with the existing mounting screws (M5).
3. Repeat STEPS 1
Mounting screw (M5)
S E C T I O N 4 — S E A T / B A C K
The seat height, seat depth, back angle, seating system, size/position of the rear
wheels, size/position of the front castors, seating options (e.g. headrest, back
bag, ...) as well as the user condition directly relate to the stability of the
wheelchair. Any change to one or any combination of the nine may cause the
wheelchair to decrease in stability. Refer to table on page 6.
After ANY adjustments, repair or service and BEFORE use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may occur.
2 for the opposite side if necessary.
-
FIGURE 3.3 Replacing Armrest Arm Pad
W A R N I N G
1 3
Armpad
Armrest assembly