Power Up The Detector - Honeywell Lyric W1 Installation Instructions Manual

Power up the detector

It is important to install the app before you
install the batteries.
After the batteries are installed, the
detector will begin attempting to pair with
the app immediately.
If you are installing multiple detectors,
the easiest way to do it is to install the
batteries in one leak detector at a time.
If you have more than one leak detector
attempting to pair with the app, you will
see multiple MAC IDs listed in the app.
Remove the battery cover and the batteries
to see the detector's MAC ID label.
The detector is powered by 3 AA batteries (included). Open the battery cover on the
detector and install the batteries.
1
Remove the battery cover from the detector.
2
Install the 3 AA alkaline batteries (included).
3
Replace the battery cover. Press firmly around the edges to ensure a snug fit.
Note: The cable sensor jack is NOT for plugging in a power adaptor. Plugging in a
power adaptor could damage the detector.
5
For help, go to getconnected.honeywell.com