Zanussi ZOB140 User Manual page 11

Use the same oven lamp type.
4. Install the glass cover.
Cleaning the oven door
The oven door has two glass panels. You can
remove the oven door and the internal glass
panel to clean it.
The oven door can close if you try to re-
move the internal glass panel before you
remove the oven door.
Caution! Do not use the appliance without
the glass panels.
1
Open the door
fully and hold the two
door hinges.
3
Close the oven
door to the first open-
ing position (halfway).
Then pull forward and
remove the door from
its seat.
www.zanussi.com
2
Lift and turn the
levers on the two
hinges.
4
Put the door on a
soft cloth on a stable
surface.
5
Release the lock-
ing system to remove
the internal glass pan-
el.
2
1
7
Carefully lift (step
1) and remove (step
2) the glass panel.
Clean the glass panel with water and soap. Dry
the glass panel carefully.
Installing the door and the glass panel
When the cleaning is completed, install the
glass panel and the oven door. Do the above
steps in the opposite sequence.
The screen-printing zone must face the inner
side of the door. Make sure that after the instal-
lation the surface of the glass panel frame on
the screen-printing zones is not rough when you
touch it.
Make sure that you install the internal glass pan-
el in the seats correctly. Refer to the illustration.
90°
6
Turn the two fas-
teners by 90° and re-
move them from their
seats.
11