Table of Contents
Advertisement
Owner's Manual
Line Input: This balanced XLR connection can be used for line-level devices such as
keyboards, drum machines, and sound modules. You can also use the line inputs on
two stereo-linked ADL 700s to give a stereo mix an extremely full, rich character. To
use this input, turn the Source Select switch to the Line position.
Comp Link: Use this TRS connection to link the compressor stage of two ADL 700s.
Power User Tip: You can leave your ADL 700s connected via the Comp Link jack at all
times, even if you only use the Stereo Link function occasionally. Unless one of the units
has its Threshold knob switched to the ST position, the two units will act independently.
Output: The ADL 700's output jack employs a balanced XLR connection.
Power User Tip: All input and output connectors are transformer-
balanced XLRs with the following wiring standard:
Pin 1: GND
Pin 2: High (+)
Pin 3: Low (-)
IEC Power Connection: Your ADL 700 accepts a standard IEC cord.
Note: The input power voltage is set at the factory to correspond with the country to
which the ADL 700 was shipped.
Master Controls
2.5
English
Español
Deutsch
Français
9
Advertisement
Table of Contents
