Advertisement
#2. Here is a picture of the drum with showing inside fins.
#3. Here is a picture of the spit rod assembly that fits into the drum unit. When fitting
into the drum assembly, be sure to first enter the drum from the UNDETACHABLE side,
putting the 2 tines into that cap and pushing through until its flanges hit the cap. After
doing such you will then align the swingable cap, making sure the 2 tines stick through the 2 holes provided on
that cap:
REMEMBER: It is prior to putting on the gear assembly, that you would
fill the cylinder with your unroasted coffee beans, making
sure beans do not spill out during this assembly!
After making sure the tines are sticking through that end cap you would then put on
the remaining gear assembly so that it looks like the following picture:
PDF Created with deskPDF PDF Writer - Trial :: http://www.docudesk.com
Advertisement
