Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Applied Comfort NAEC SERIES
Summary of Contents for Applied Comfort NAEC SERIES
- Page 1 NAEC SERIES UPFLOW PACKAGED TERMINAL AIR CONDITIONER (PTAC) Cooling with Electric Heat INSTALLATION & OPERATION MANUAL IMPORTANT: READ AND SAVE THESE INSTRUCTIONS. INSTALLATION AND WIRING MUST BE IN ACCORDANCE WITH CEC, NEC AND LOCAL ELECTRICAL CODES. 803877 Rev. 00...
-
Page 2: General Information
This Applied Comfort PTAC is designed and built for pollutants circulating in the outdoor and indoor through-the-wall installation in either new or existing operating environments. - Page 3 Oiling ELECTRICAL WIRING AND RECEPTACLE The motors are permanently lubricated and hence need WIRE SIZING no re-oiling. A single outlet branch circuit from the main electrical Unimpeded Indoor Airflow panel to the receptacle in the wall should be used. Wire sizing shall be in accordance with the minimum Ensure that drapes, bed, bedspread, and furniture etc.
-
Page 4: Chassis Installation
230-208 and 115 volt units are true “cord connected units”, and are provided with a service cord of the LCDI (Leakage Current Detection Interrupter) type, intended to be plugged in to a wall receptacle. The LCDI cord is capable of detecting some of the common faults experienced with aging power cords, and interrupts power to the cord before a hazardous condition can evolve in the cord. - Page 5 If the unit is equipped with a powered damper, it will open and close whenever the indoor NAEC series is available with advanced-function fan is operated on high speed, as the factory default. electronic controls with membrane switch type keypad.
- Page 6 On/Off Key Each press of the key toggles the unit from an OFF state to an ON state or from an ON state to an OFF state. Heating and cooling functions, as well as the display, and all indicating LEDs except for the fan indicators, are enabled or disabled with this key.
-
Page 7: Thermostat Location
Set Fan Mode Press Fan key to cycle through the fan settings as The final step is to apply the masking label provided, indicated by the small green circular LEDs. Select to cover up the keypad. The keypad and display will be continuous High Speed fan, continuous Low Speed disabled and no longer be available for control. -
Page 8: Remote Thermostat Operation
REMOTE THERMOSTAT OPERATION When the unit is first plugged in, or when recovering from a power outage, there will be a random 5 to 15 second delay before the electronic control powers up. The keypad will be totally disabled once the DIP switch has been set for remote mode. -
Page 9: Wall Thermostat Operation
either keypad or remote thermostat application, as long as the unit is plugged in, power is available, and a heat WALL THERMOSTAT OPERATION source is configured in the unit and is working. Heat Sets the unit into heating mode. Compressor Short-Cycle Protection Initiates heating when room If the electronic control shuts the compressor down for temperature falls below set point. - Page 10 Automatic Powered Damper Some units may be provided with an automatic powered fresh air damper that opens the fresh air door to bring outdoor air into the room whenever the indoor fan is running on high speed. If the indoor fan shuts off, the damper automatically closes.
Need help?
Do you have a question about the NAEC SERIES and is the answer not in the manual?
Questions and answers