Panasonic DMR-EH75V Operating Instructions Manual page 17

DirecTV/DISH Network service is only available in the United States.
cl
To household
AC outlet
(AC 120 V, 60 Hz)
• If your television does not haw
AUDIONIDEO terminals
(4 t e, !_11).
• If you enjoy higher picture
quality. (4 21, 22)
This unit
Audio/Video cable
Cable from
wall or Satellite antenna
antenna signal (satellite receiver only)
75 _ coaxial
cable
75 _ coaxial
ble (included)
i
l 75 _ coaxial cable
AC power supply cord (included) ,_
Connect only after all other
connections are complete. Z
IRe B I_eStoewr (in cIu d e d)
Cable box or DirecTV receiver
To household AC outlet
(AC 120 V, 60 Hz)
AC power supply cord I l
(included)
Connect only after all other
connections are complete.
_
IR Blaster
(included)
See below
Satellite antenna (satellite receiver only)
Cable box or DirecTV receiver
Cable from wall or
antenna signal
i
75 G coaxial cable --
This unit
• If your television does not have
AUDIO/VIDEO terminals
(4 19, m).
• If you enjoy higher picture
quality. (4 21,22)
Why should I connect the IR Blaster?
Audio/Video cable (included)
Video cassette recorder
O
cable
The IR Blaster is necessary for operating a cable box or DirecTV receiver with this unit's remote control. Additionally, if the IR Blaster is not
correctly connected or set up, you cannot make scheduled recordings or download program listings.
Setting the IR Blaster
Place the IR Blaster in front of the signal sensor of the cable box or DirecTV receiver.
Read the cable box or DirecTV receiver If necessary, use the double sided adhesive tape (included) to secure the IR Blaster to a flat surface.
operating instructions regarding Television stand surface
positioning of the signal sensor. _eel off the adhesive tape, the surface may become damaged.
Once you have confirmed the cable box or DirecTV receiver is
operating correctly, secure it by attaching the adhesive tape.
Cable box or DirecTV receiver
RQT8346