Marantz AV7703 Owner's Manual page 278

Contents Connections
Symptom
DTS Neural:X cannot be selected when using the headphones.
DTS Neural:X mode cannot
0
be selected.
Dolby Surround mode Dolby Surround cannot be selected when using the headphones.
0
cannot be selected.
Only "Stereo" or "Direct" can be selected for the sound mode if Headphone:X signals are input.
Sound modes other than
0
"Stereo" or "Direct" cannot
be selected.
These cannot be selected when you have not performed Audyssey
Audyssey MultEQ ® XT32,
0
Audyssey Dynamic EQ ® ,
Switch to a sound mode other than "Direct" or "Pure Direct".
0
Audyssey Dynamic
These cannot be selected when using the headphones.
0
Volume and Audyssey
®
LFC™ cannot be selected.
"M-DAX" cannot be Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. For playback of
0
multichannel signals such as Dolby Digital or DTS surround, "M-DAX" cannot be used.
selected.
Switch to a sound mode other than "Direct" or "Pure Direct".
0
No audio is output from In ZONE2/ZONE3, the audio can be played back when signals input from digital connectors (OPTICAL/
0
COAXIAL) are in 2ch PCM format.
PRE OUT for ZONE2/
ZONE3.
In ZONE2, the audio can be played back when signals input from the HDMI connector are in 2ch PCM
0
format. To play back the audio in ZONE2 irrespective of the input signal format, set "HDMI Audio" in the
menu to "PCM". Depending on the played back device, the audio may not be played back even with this
setting. In that case, set the audio format to "PCM (2ch)" on the played back device.
When listening to audio from a Bluetooth device in ZONE2/ZONE3, remove any obstructions between the
0
Bluetooth device and this unit and use it within a range of about 98.4 ft/30 m.
Front panel Display
Playback Settings
Cause / Solution
278
Rear panel
Tips
® Setup.
Remote Index
Appendix
Page
－
－
－
206
141
－
180
141
－
245
－