Trouble Shooting; Environmental Protection; Available Accessories - Powermatic 4224B Operating Instructions Manual

spindle so you do not mushroom end of spindle).
Go only far enough to remove the belt from spindle.
To reassemble reverse the procedure.
When reinstalling clamping nut, thread it on to the spindle
until its snug. Then back off slightly and tighten the lock
washer.
Note:
To remove the pulley for bearing replacement it is needed
to loosen the 2 set screws (E, Fig 42).
Fig 42
Make sure the pulleys are oriented properly after
reassembly for straight belt running.

9. Trouble shooting

Motor doesn't start
*No electricity-
check mains and fuse.
*Defective switch, motor or cord-
consult an electrician.
*Overload detected on AC-drive unit-
wait and restart machine; chose low speed range belt
setting (0-910 rpm) for better torque.
Machine vibrates excessively
*Stand on uneven floor-
adjust stand for even support.
*Workpiece is not properly centred
*The speed is too high

10. Environmental protection

Protect the environment.
Your appliance contains valuable materials which can be
recovered or recycled. Please leave it at a specialized
institution.

11. Available accessories

Stock number 6294905
Bed extension 508mm with tool rest shaft extension
(Fig 43)
Fig 43
Stock number 6294904
Bed Extension 1600mm with stand (Fig 44)
Fig 44
Stock number 6294903
Tailstock Riser Block (Fig 45)
Fig 45