Advertisement
1-8 .
,
j
xv-ClOU
Now
lift the top cabinet
further
up and
disconnect
the leaf switch connectors
(LL) as
well as the operation
key unit flat cable (KE).
The top cabinet is now free.
Disconnect the connector (PE) of the AC cord
(that runs through the rear cabinet) from the
ballast unit. Detach the rear cabinet.
Remove the spacer.
Remove the screws off the lens Cover.
Top Cabinet
1-12. Disconnect
the speaker connector
(SP) and
remove the three lock screws.
Remove fb
cpra\br r\ff thn
mrnl
lnrl
lasrd
Nnw detarh
the cil
I
n
1. Fit the lens cover and the side cover to the bottom panel. Tighten up the related screws.
2. Set the top cabinet over the bottom cabinet.
3 . Tighten up the M3 tapping screw into the sub unit cover.
4 . Press the rear cabinet against the top and bottom cabinets to fit them together.
5 .
6 .
7.
Tighten up the screws into the rear cabinet.
Use the six 3-mm tapping screws.
Tighten up the tapping screws to fix the top and bottom cabinets.
Put the lamp/cage module unit into position. Tighten up the two 4-mm screws.
Place the lamp cage cover and tighten up the screws.
11
Lens Cover
.
Side Cover
Reassembling procedure
8 .
Advertisement
