Table of Contents
Advertisement
the flight.
Check whether the electricity quantities of the battery and the remote controller are full enough
to support the flight.
Make sure the engine arm and the foot stool are in place, and the propeller has been fixedly
installed.
Check whether the connection between the remote controller and the aircraft is normal.
Check whether all firmware versions are the latest. And check whether the APP and the remote
controller are connected normally.
Check whether the electric motor and the gimbal are working normally after it is electrified.
Make sure that the SD card has been inserted into the camera.
Accelerator Calibration
When the aircraft leaves the factory, the accelerometer has already been calibrated. It is suggested
to calibrate it again before the first flight to ensure the flight security according to the following
steps.
Visit www.prodrone-tech.com to download and install the 'Byrd Parameter adjustment software
of the aircraft' on the PC end.
Connect the parameter adjustment port of the aircraft with the PC, the parameter adjustment
software would identify the hardware of aircraft automatically.
Put the aircraft horizontally, enter the preface of 'Accelerometer' in the parameter adjustment
software, and click the 'Click to start the single axis calibration'.
Wait for three seconds and the calibration is finished.
※
Make sure the aircraft has been turned off before it is connected to the PC.
Compass Calibration
Power on the remote control and then the aircraft. At this time, the aircraft will start a self-check
and a series of beeps will sound.
After the beep stops, toggle the "Flight Mode Switch" back and forth for several times. Observe
the color of the LED indicator light in the aircraft and stop toggling when the yellow LED
indicator light at the head of the aircraft is on and the yellow light at the tail flashes slowly.
31
Advertisement
Table of Contents
