Remote Controller Preparation - ProDrone Byrd User Manual

7. Charging
The power battery of could not be charged when it is in the aircraft. Please take it down from the
aircraft and charge it with the charger. It takes about 2.5 hours to finish the charging.
In charging, the LED indicator light in the charger is red. When the light turns green, it means the
battery has been fully charged. Please disconnect the charger timely.
※
Make sure to use the original charger to charge the battery and the remote controller. ProDrone will
shoulder no responsibilities if faults and damages are caused by not using the original accessories.
※
If the type of the charger plug does not match with that of the power plug, please visit the official mall
to buy the same type of the power line.

Remote Controller Preparation

1. ON/OFF
Press the power switch of the remote controller for three seconds, and it will be turned on.
Repeat this operation and the remote controller will be turned off.
2. Battery Check
The electric quantity of the remote controller is shown through the color of the back light of the
power switch. If it is green, it means the electric quantity is enough for the flight; if it is red, it
means the quantity is not enough and it needs to be charged.
27