Fiat ABARTH 500 2017 User Manual page 59

OPERATING YOUR VEHICLE
To Set A Desired Speed
Turn the Speed Control on. When the vehicle has reached the desired speed, push
the SET (-) button and release. Release the accelerator and the vehicle will operate
at the selected speed.
NOTE:
The vehicle should be traveling at a steady speed and on level ground before pushing the
SET (-) button.
To Deactivate
A soft tap on the brake pedal, pushing the CANC button, or normal brake pressure
while slowing the vehicle will deactivate Speed Control without erasing the set
speed memory. Pushing the ON/OFF button or turning the ignition switch OFF
erases the set speed in memory.
To Resume Speed
To resume a previously set speed, push the RES (+) button and release. Resume
can be used at any speed above 25 mph (40 km/h).
To Vary The Speed Setting
To Increase Speed
When the Speed Control is set, you can increase speed by pushing the RES (+)
button.
The driver's preferred units can be selected through the Uconnect settings if
equipped. Refer to "Uconnect Settings" in "Understanding Your Instrument Panel"
in the Owner's Manual at www.fiatusa.com/en/owners/manuals for more informa-
tion. The speed increment shown is dependent on the selected speed unit of
U.S. (mph) or Metric (km/h):
U.S. Speed (mph)
• Pushing the RES (+) button once will result in a 1 mph increase in set speed.
Each subsequent tap of the button results in an increase of 1 mph.
• If the button is continually pushed, the set speed will continue to increase until the
button is released, then the new set speed will be established.
Metric Speed (km/h)
• Pushing the RES (+) button once will result in a 1 km/h increase in set speed.
Each subsequent tap of the button results in an increase of 1 km/h.
• If the button is continually pushed, the set speed will continue to increase until
the button is released, then the new set speed will be established.
57