Fiat ABARTH 500 2017 User Manual page 105

WHAT TO DO IN EMERGENCIES
Vehicles equipped with the Anti-Lock Brake System (ABS) are also equipped with
Electronic Brake Force Distribution (EBD). In the event of an EBD failure, the Brake
Warning Light will turn on along with the ABS Light. Immediate repair to the ABS
system is required.
Operation of the Brake Warning Light can be checked by turning the ignition switch
from the OFF position to the ON/RUN position. The light should illuminate for ap-
proximately two seconds. The light should then turn off unless the parking brake is
applied or a brake fault is detected. If the light does not illuminate, have the light
inspected by an authorized dealer.
The light also will turn on when the parking brake is applied with the ignition switch
in the ON/RUN position.
NOTE:
This light shows only that the parking brake is applied. It does not show the degree
of brake application.
— Malfunction Indicator Light (MIL)
Certain conditions, such as a loose or missing gas cap, poor fuel quality, etc., may
illuminate the MIL after engine start. The vehicle should be serviced if the light stays
on through several typical driving cycles. In most situations, the vehicle will drive
normally and not require towing.
If the MIL flashes when the engine is running, serious conditions may exist that
could lead to immediate loss of power or severe catalytic converter damage. We
recommend you do not operate the vehicle. Have the vehicle serviced immediately.
— Electronic Stability Control (ESC) Activation / Malfunction
Indicator Light
The "ESC Activation/Malfunction Indicator Light" in the instrument cluster will come
on for four seconds when the ignition switch is turned to the ON/RUN position.
If the "ESC Activation/Malfunction Indicator Light" comes on continuously with the
engine running, a malfunction has been detected in the ESC system. If this light
remains on, see your authorized dealer as soon as possible to have the problem
diagnosed and corrected.
NOTE:
• The "ESC Off Indicator Light" and the "ESC Activation/Malfunction Indicator
Light" come on momentarily each time the ignition switch is turned to ON/RUN.
• Each time the ignition is turned to ON/RUN, the ESC system will be ON even if it
was turned off previously.
• ESC Activation/Malfunction Light can blink during a ESC or TC intervention.
— Generic Warning Light
The Generic Warning Light will illuminate if any of the following condition occurs:
Engine Oil Pressure Sensor Failure
103