2-Channel And Mixed-Mono Input Wiring Diagram - Audiovox Rampage AXT-500 Owner's Manual

2-CHANNEL MONO (BRIDGED) INPUT WIRING DIAGRAM
LOW-LEVEL
RCA OUTPUTS
Right
Left
USE EITHER HIGH-LEVEL OR
LOW-LEVEL INPUT, NOT BOTH.
RCA TYPE
SHIELED CABLES
(NOT INCLUDED)
(SPEAKER) OUTPUTS
CAR STEREO
Left Front +
Right Front +
Left Rear +
Right Rear+
CHASSIS GROUND ON RADIO
IMPORTANT
TO CH1 / CH2
TO CH3 / CH4
4CH 4CH 2CH 2CH
X-OVER X-OVER
PWR PWR
PRT PRT
FULL FULL LPF LPF
50Hz 50Hz 250Hz 250Hz MIN MIN MAX MAX
LPF LPF GAIN GAIN
3CH 3CH 1CH 1CH
-12-
HIGH-LEVEL
NOTE: When using High-Level (Speaker) Outputs
of car stereo, connect only the Positive (+)
wires to the amplifier. Do not use Negative (-)
Output wires (insulate ends with tape and
leave disconnected)
(WIRE SIDE VIEW)
HI-INPUT HI-INPUT
X-OVER X-OVER
4CH 4CH 1CH 1CH
3CH 3CH 2CH 2CH
FULL FULL LPF LPF
GND GND
MIN MIN MAX MAX 50Hz 50Hz 250Hz 250Hz
GAIN GAIN LPF LPF