Operation Method - Westinghouse HT351G12 Instruction Manual

1. Preparation Before Ignition
• Make sure the type of gas used complies with that stipulated in the label.
• Open the ventilation holes.
• Turn on the gas inlet valve.
2. How to ignite
• Turn on the water valve (make sure
there is water flowing out of the
shower), the green indicating light
will turn on with "clicking" ignition
sound. The burner is ignited and hot
water flows out instantly. If the water
pressure is low, or the power is not
connect, the water heater will not
aperate normally.
• After initial installation or a change
of gas cylinder air may remain in the
gas pipe and it requires several ignition
attempts to push the air out of the pipe
before the gas can be ignited. If a
problem comes up after normal
operation, turn off the water
immediately. Try to re-ignite 10-20
seconds later to avoid "pop" burning.
• Water Temperature Control
(1) Turn the water flow control knob (rob)
on the cover of (under) the machine
to control the water flow and its
temperature. Turn the gas regulator
knob (rod) on the cover (bottom) to
control the flame of the burner thus
controlling the hot water temperature.

OPERATION METHOD

Fig. 11
Fig. 10
Power switch
Don't touch
Fig. 12