Adjustment And Confirmation Procedures - Integra DTR-6.4 Service Manual

ADJUSTMENT AND CONFIRMATION PROCEDURES 1

Idling current adjustment
Before Idling adjustment, turn the trimming resistors R6040 to R6045 to counter clockwise.
Connect the DC voltmeter to sockets P6080 to P6085.
After turn POWER to ON, adjust the trimming resistors R6040, R6041 and R6042 so that the reading of
voltmeter becomes 2.5 mV. (Front and center channels)
Adjust the trimming resistors R6043, R6044 and R6045 so that the reading of
voltmeter becomes 1.5 mV. (Surround and surround back channels)
After adjustment, attach the top cover.
Confirm the voltage of points above after about five minutes.
Front and center channels
When less than 10.0 mV, readjust the resistors above so that the voltage becomes 10.0 mV.
When 10.0 mV to 12.0 mV, you are not necessary to adjust.
When more than 12.0 mV, readjust the resistors above so that the voltage becomes 12.0 mV.
Surround and surround back channels
When less than 7.0 mV, readjust the resistors above so that the voltage becomes 7.0 mV.
When 7.0 mV to 9.0 mV, you are not necessary to adjust.
When more than 9.0 mV, readjust the resistors above so that the voltage becomes 9.0 mV.
Note: No load and No signal
P6080
R6040
L
BIAS
Confirmation of protection circuit
1. Confirmation of operation of speaker relay
Confirm that the speaker relays turn ON approximate. 5 seconds after the power switch is turned ON.
Confirm that the speaker relays turn OFF immediately after the power switch is turned OFF.
2. Confirmation of DC detection circuit
Press and hold down CD button, then press STANDBY/ON button to set the unit to
"Test-1" mode.
After "Test-1" on the FL tube light on, press VIDEO 1 button to set the unit to "Test-1-00".
Apply DC 1.5 to 3V to DVD INPUT terminal with no load.
Confirm that the speaker relay turns OFF.
Apply DC -1.5 to -3V to DVD INPUT terminal with no load.
Confirm that the speaker relay turns OFF.
After "Test-1" on the FL tube light on, press REC OUT button two times to set the unit to "Test-1-02".
Apply DC 1.5 to 3V to DVD INPUT terminal with no load. Confirm that the speaker relay turns OFF.
Apply DC -1.5 to -3V to DVD INPUT terminal with no load. Confirm that the speaker relay turns OFF.
Caution: Don't apply DC voltage more than 1 sec..
NCAF-7966
P6081
R6041
R6042
P6082
BIAS
C
R6044
R6043
P6084
P6083
BIAS
BIAS
LS
RS
SB
DTR-6.4
R6045
BIAS