Installation Instructions - Danby DKC052BSL2DB Owner User Manual

Installation Instructions

Before Using Your Keg Cooler
• Remove the exterior and interior packaging.
• Check to be sure you have all the following parts:
• 1 Safety Guard Rail
• 1 drip tray (2 pieces)
• 1 CO Cylinder support
2
• 1 CO Regulator
2
• 1 CO Empty Cylinder
2
• 2 CO Gas line hose (coloured)
2
• 2 Beer Hose
• 2 Beer keg couplers
• 1 Beer tower
• 2 Pull handle (Beer tower faucet)
• 4 Plugs: For guard rail holes
• 1 metal plate for cabinet bottom
• 3 Wire shelf
• 2 steel clamps for coloured hose
• 2 metal washers for front casters
• 4 Casters (2 front with locks)
• 1 Rubber Gasket (may not be required in all unit confi gurations)
• Before plugging in the keg cooler, let it stand upright for approximately 2 hours. This will reduce the possibility of a
malfunction in the cooling system from handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
Installation of Keg Cooler
• This appliance is designed to be free standing only and should not be recessed or built-in.
• Place your keg cooler on a fl oor that is strong enough to support the keg cooler when it is fully loaded.
• Allow 3 inches of space between the back and sides of the keg cooler, which allows the proper air circulation to cool
the compressor.
• Locate the keg cooler away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight may
affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient temperatures
may also cause the keg cooler not to perform properly. This unit is not designed for outside installation (i.e. garages,
porches, etc.).
• Avoid locating the keg cooler in excessive humidity.
• Plug the keg cooler into a dedicated, properly installed-grounded wall outlet. Do not under any circumstance cut or
remove the third (ground) prong from the power cord. Any questions concerning power and or grounding should be
directed toward a certifi ed electrician or an authorized service centre.
• After plugging the appliance into a wall outlet, allow the unit to cool down for 2-3 hours before placing any contents in
the keg cooler compartment.
Electrical Connection
• The keg cooler should be properly grounded for your safety. The power cord of this keg cooler is equipped with a
three-prong plug which mates with standard three prong wall outlets to minimize the possibility of electrical shock.
• Do not under any circumstance cut or remove the third ground prong from the power cord supplied.
• Use of extension cords is not recommended.
WARNING
Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is dam-
aged, have it replaced by an authorized service centre.
5