Electrolux EOD5720AAX User Manual page 26

26 www.electrolux.com
2. Pull the rear end of the shelf support
away from the side wall and remove
it.
1
Install the shelf supports in the opposite
sequence.
The retaining pins on the
telescopic runners must
point to the front.
11.4 Catalysis
CAUTION!
Do not clean the catalytic
surface with oven sprays,
abrasive cleaning agents,
soap or other cleaning
agents. This will damage the
catalytic surface.
Remove all accessories and removable
shelf supports.
The walls and the top of the cavity are
catalytic-coated. They absorb fat and dirt
at a big heat without smell.
To support this self-cleaning process
heat the appliance without any food
regularly.
Spots or discolouration of
the catalytic surface have no
effect on catalytic properties.
1. Touch
display shows "Cata" and the
2
again and again until the
duration of the cleaning procedure (1
hour).
You cannot set the Duration, but you
can use the End function to delay the
start of the cleaning procedure.
An acoustic signal sounds after the time
ends. The appliance deactivates.
2. Touch a sensor field or open the
oven door to stop the acoustic signal.
3. Clean the bottom of the appliance
with a soft and moist sponge.
11.5 Removing and installing
the door
You can remove the door and the
internal glass panels to clean it. The
number of glass panels is different for
different models.
WARNING!
Be careful when you remove
the door from the appliance.
The door is heavy.
1. Open the door fully.
2. Fully lift up the clamping levers (A)
on the two door hinges.
A
3. Close the door until it is at an angle
of approximately 45°.
45°
A