Table of Contents
Advertisement
■ Lamp replacement
When the life of the projection lamp of this LCD Projection
Wh
the e
he p oject n lamp o
Monitor draws to an end, the LAMP REPLACE indicator lights
orange. If this indicator lights orange, replace the lamp with a
new one promptly.
CAUTION
Allow a LCD Projection Monitor to cool, for at least
30 minutes before you open the Lamp cover. The
inside of the LCD Projection Monitor can become
very hot.
Follow these steps to replace the lamp assembly.
1
Turn off the LCD Projection Monitor and disconnect the
AC plug. Allow the LCD Projection Monitor to cool for at
least 30 minutes.
Remove the Left front cover of the LCD Projection Monitor.
2
a. Hold left upper side of the cover and slightly pull
forward.
b. Hold both sides of the cover and remove it.
b. Ho
o ld
ld
l
b ot
b
b b
ot
oth
h
side
ides o o f th h e cover
3
Loosen 4 screws that secure the Lamp Cover with a
screwdriver and remove the Lamp Cover.
4
Loosen the 2 screws that secure the lamp with a
screwdriver and pull out the Lamp by grasping the handle.
5
Replace the Lamp with a new one and tighten the 2
screws. Make sure that the Lamp is correctly secured into
the Lamp compartment.
replacement lamp.
6
Put the Lamp Cover back and tighten the 4 screws, and
then replace the Left front cover.
7
Connect the AC Power Cord to the LCD Projection
Monitor and turn on the LCD Projection Monitor.
8
Reset the Lamp replace counter.
See "Lamp replace counter reset" on the next page .
CAUTION;
When installing the new Lamp into the Lamp compartment,
make sure the Lamp socket is securely plugged into the com-
par
partmen
partment socket. Improper or loosen socket connection may
a
en
nt sock
prop
cause arc discharge resulting fire hazard.
di
h
l
is CD P ojec
it.
it
Refer to ordering the
et
r o
r loos
en socket
conne
ction
i
fi
d.
This indicator lights orange
when the life of the projection
lamp draws to an end.
CAUTION
For continued safety, replace with a lamp of the
same type. Do not drop a lamp or touch a glass
bulb! The glass can shatter and may cause injury.
Pull this
part first.
Screws
the
com
may
- 11 -
Front Control
LAMP
REPLACE WARNING
Left Front
Cover
Screws
Lamp Cover
Handle
Advertisement
Table of Contents
