Makita 6823 Technical Information page 4

R
epair
< 1 > When installing ring 20, its grooved surface
has to be in contact with spindle.
(see Fig.1.)
< 2 > When installing thrust needle
bearing 821,its thick washer
has to be faced to gear complete.
(see Fig.2.)
< 3 > Insert compression spring 8 into spindle
by turning it with thick axis of gear complete.
(see Fig.3.)
Surface without groove
Fig.1
Spindle
Gear complete
Fig.2
Compression
Spindle
spring 8
Fig.3
Grooved surface
This side has to be in
contact with spindle.
Ring 20
Thrust needle bearing 821
Gear complete.
Gear complete