Fein ASte 636 Operating Instructions

ASte 636
To be handed to the workshop!
Operating instructions
for the double insulated and radio suppressed
Electric Hack Saw
type ASte 636 with electronic two-speed switch
I. Technical Data
Type of current: A. C."' 220 V
Incisions
Type
per minute
in.
1st speed 1600
ASte 636
3/4
2nd speed 700
2. Construction
The hack saw ASte 636 is an electric hand tool of Class II in ac-
cordance with the VDE regulations 0740. In addition to the nor-
mal insulation the tool is equipped with a further protective in-
sulation which protects the user from electric accidents that may
arise from a wrong normal insulation. The shockproof motor
housing made of Polyamide forms the insulation of the pole
housing, whereas the live parts of the. armature are separated
from the driving shaft by an intermediate insulation. The ma-
chine is supplied with a two core cable without earthing con-
ductor and must not be earthed. The insulation is tested with
the prescribed test voltage of 4000 Volts. The machine is radio
suppressed in accordance with radio interference degree N.
To prevent the overbridging of the insulation no additional mark-
ing plates and signs must be riveted or screwed on the housing.
We recommend the use of transfers only.
3. Connection and Operation
Before plugging the tool into plain or safety sockets check that
voltage stated on the rating plate is in accordance with the volt-
age of the mains supply. Switch must be in the "Off" position
when connecting.
Stroke Input Output Weight
Watts Watts
I
mm lbs.
I
kg
20
2=--
~
4.7 2.1
280
150
Unscrew handle (60) combined with the hexagon pin and open
screw (51) on plunger (37) . Put saw blade chosen for the work-
piece into the slot of the plunger and clamp with pin of handle
(60) and screw (51).
Usually the cutting table
(52)
is screwed so that the vaulted side
points into the cutting direction. In special cases and for placing
reasons e. g. if you want to cut near a vertical wall the table can
be turned by
180
°
and screwed.
The ventilation air blows the saw-dust away from the saw-blade
so that the tracing line is always visible.
Attention! Change incisions only at stand-still.
4. Maintenance
Before carrying out any maintenance work always remember
to pull out the plug.
To guarantee the safety given by the protective insulation the
machine must be cleaned regularly after 300 duty hours. Blow
or brush out the tool with special attention to carbon brush hol-
ders, insulated and electronic parts.
For the checking of the carbon brushes take out carbon brush
holders
(10)
after unscrewing the screws
(12) .
After checking the
carbon brushes be sure to lodge them in their original position
BE 244/e
BX 5. 68 Printe d in German y
I
From August 1970, gear and ball bearings are provided with the special
grease
Sst
1.
Correct quantity for gear 80 g.