Table of Contents
Advertisement
WWW.FREESERVICEMANUALS.INFO
[SERVICE POSITION TO CHECK THE CAMERA SECTION]
Connection to Check the Camera Section
To check the CAMERA section, set the CAMERA to the "Forced camera power ON" mode.
To obtain the focus manually, connect both of the FP-538 board and the FP-539 board.
Setting the "Forced Camera Power ON" mode
1) Select page: 0, address: 01, and set data: 01.
2) Select page: 0, address: 10, and set data: 00.
3) Select page: D, address: 10, set data: 01, and
press the PAUSE button of the adjustment remote
commander.
Adjustment remote
commander (RM-95)
Cabinet (F) block assembly
CD-406 board
CN1000
Lens block assembly
CN452
(CPC)
FP-542 flexible board
CN461
CN001
CN451
VC-308 board
CN457
LANC jack
ST-076 board
CN4201
This wire must be connected
to obtain the focus manually.
12/2
Exiting the "Forced Camera Power ON" mode
1) Select page: 0, address: 01, and set data: 01.
2) Select page: 0, address: 10, and set data: 00.
3) Select page: D, address: 10, set data: 00, and press
the PAUSE button of the adjustment remote commander.
4) Select page: 0, address: 01, and set data: 00.
Control switch block
(SS-2980)
Must be connected.
DI-087 board
CN2019
CN463
CN458
CN456
CN455
CN453
Mechanism deck
FP-538 board
2-19
Worlf of free manuals
DCR-IP210/IP210E/IP220/IP220E
Cabinet (rear) block assembly
DI-087 board
CN2020
AC power
adaptor
FP-539 board
WWW.NOSTATECH.NL
DC-098 board
DC-IN connector
AC IN
Advertisement
Table of Contents
